Configuring Rate Limit On Ports - Huawei Quidway S3900 Series Operation Manual

Operation Manual - QoS&QoS Profile
Quidway S3900 Series Ethernet Switches-Release 1510
1.6.2 Configuration Procedure
Table 1-10 Set the precedence of the protocol packet
Operation
Enter
view
Set
precedence of the
protocol packet
Display
precedence of the
protocol packet
Note:
The precedence of OSPF protocol packets cannot be changed on S3900-SI series
switches.
1.6.3 Configuration Example
Set the IP precedence of the ICMP protocol packet to 3.
Display the configuration results.
Configuration procedure:
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] protocol-priority protocol-type icmp ip-precedence 3
[Quidway] display protocol-priority
Protocol: icmp
IP-Precedence: flash(3)

1.7 Configuring Rate Limit on Ports

1.7.1 Configuration Prerequisites
The ports where rate limit is to be performed is specified
The target rate is specified
The direction of rate limit is specified
Command
system
system-view
protocol-priority
protocol-type
the
protocol-type
{ ip-precedence
ip-precedence
dscp-value }
the
display
protocol-priority
Huawei Technologies Proprietary
—
Required
You can modify the IP precedence
or DSCP precedence of
protocol packet
Only the precedence of TELNET,
| dscp
OSPF, SNMP, and ICMP protocol
packets is supported currently
Optional
You can execute the display
command in any view
1-17
Chapter 1 QoS Configuration
Description
the