Optional) Configuring The Interval For Checking The Forwarding Rate Of Multicast Data; Checking The Configuration - Huawei Quidway s3700 series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Multicast
No.
1
2
3
7.11.2 (Optional) Configuring the Interval for Checking the
Forwarding Rate of Multicast Data
You can configure conditions for the SPT switchover and set the interval for checking the
forwarding rate of multicast data on the DR at the group member side.
Context
Do as follows on all the switchs that may become a DR at the member side:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
pim
The PIM view is displayed.
Step 3 Run:
spt-switch-threshold { traffic-rate | infinity } [ group-policy basic-acl-number
[ order order-value ] ]
The SPT switchover condition is set.
l traffic-rate: specifies the rate threshold of the SPT switchover.
l infinity: indicates that the SPT switchover is not triggered forever.
----End

7.11.3 Checking the Configuration

After the control parameters for SPT switchover are adjusted, you can run commands to check
entries in the PIM routing table.
Procedure
l
Issue 01 (2011-10-26)
Data
Rate threshold that a leaf PIM switch switches packets from the RPT to the SPT
Group filtering policy and sequence policy for the switchover from the RPT to the
SPT
Interval for checking the rate threshold of multicast data before the RPT-to-SPT
switchover
Run the following commands to check the PIM routing table.
– display pim routing-table [ group-address [ mask { group-mask-length | group-
mask } ] | source-address [ mask { source-mask-length | source-mask } ] | incoming-
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 PIM-SM (IPv4) Configuration
174