Maintaining The Mac Address Table; Debugging The Mac Address Table; Configuration Examples - Huawei Quidway S9300 Configuration Manual

6 MAC Address Table Configuration
Procedure
Step 1 Run the display mac-limit [ interface-type interface-number [ vlan vlan-id ] | vlan vlan-id |
[ vsi vsi-name ] ] command to display the rule of limiting MAC address learning.
----End
Example
By running the display mac-limit command, you can check whether the configuration of the
limitation on MAC address learning is correct.
<Quidway> display mac-limit
MAC Limit is enabled
Total MAC Limit rule count : 1
PORT
----------------------------------------------------------------------------
GigabitEthernet1/0/1

6.5 Maintaining the MAC Address Table

This section describes how to maintain the MAC address table.

6.5.1 Debugging the MAC Address Table

6.5.1 Debugging the MAC Address Table
Context
Debugging affects the performance of the system. So, after debugging, run the undo debugging
all command to disable it immediately.
When the MAC address table runs abnormally, run the following debugging command in the
user view to debug the MAC address table, view the debugging information, and locate and
analyze the fault.
Procedure
Step 1 Run the debugging ethernet packet mac { dest_mac mac-address | src_mac mac-address }
command to debug the Ethernet packets with the specified source MAC address or destination
address.
----End

6.6 Configuration Examples

This section provides several examples for the configuration of the MAC address table.
6-10
VLAN/VSI
-
CAUTION
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
Maximum Rate(ms) Action
10000 - discard enable
Alarm
Issue 03 (2009-08-20)