Field Service Ver. 1.0 Jul. 2006
8.2.6
BUZZER VOLUME
Function
• To set the volume of alarms and the beep sounded when a key is pressed.
Use
• The default setting is LOW.
Setting/
procedure
HIGH
8.2.7
INITIAL MODE
Function
• To set the mode (Copy mode or Fax mode) that the machine starts up in or returns to
after the Control Panel is reset.
Use
• The default setting is COPY.
Setting/
procedure
"COPY"
8.2.8
TONER EMPTY STOP
Function
• Specifies whether to stop or continue printing when a toner empty condition is detected.
Use
• To permit printing upon a toner empty condition.
• The default setting is ON.
"ON"
Setting/
procedure
ON: If [ON] is selected, printing, copying and faxing stop when the toner runs out.
ON (FAX): If [ON (FAX)] is selected, only faxing stops when the toner runs out.
OFF: If [OFF] is selected, printing, copying and faxing do not stop when the toner runs out.
8.2.9
AUTO CONTINUE
• Enables or disables printing when the size of the media loaded in the tray does not
Function
match that of the print data.
• To print data on the media loaded in the tray if the media loaded in the tray does not
Use
match that of the print data.
• The default setting is OFF.
Setting/
procedure
ON
8.2.10
CALIBRATION
Function
• Executes the image stabilization sequence.
• To calibrate the engine when there are print image quality problems.
Use
• To calibrate the engine when the transfer belt unit and 2nd transfer roller are replaced
with new ones.
• The default setting is OFF.
ON
Setting/
1. Select [MACHINE SETTING] and then [10 CALIBRATION], and press the Menu Select
procedure
key.
2. Select [ON] and press the Menu Select key.
3. Image stabilization is executed.
"LOW"
OFF
FAX
ON (FAX)
OFF
"OFF"
"OFF"
8. Menu mode
83