Configuring Spanning Tree Bridge Parameters
clear spantree priority
Use this command to reset the Spanning Tree priority to the default value of 32768.
Syntax
clear spantree priority [sid]
Parameters
sid
Defaults
If sid is not specified, priority will be reset on Spanning Tree 0.
Mode
Switch command, Read‐Write.
Example
This example shows how to reset the bridge priority on SID 1:
Matrix(rw)->clear spantree priority 1
show spantree bridgehellomode
Use this command to display the status of bridge hello mode on the device.
Syntax
show spantree bridgehellomode
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Only.
Usage
When enabled, a single bridge administrative hello time is being used. When disabled, per‐port
administrative hello times are being used.
6-22 Spanning Tree Configuration
(Optional) Resets the priority on a specific Spanning Tree. Valid values
are 0 ‐ 4094. If not specified, SID 0 is assumed.
clear spantree priority