Set Snmp Targetparams; Show Snmp Targetparams Output Details - Enterasys Matrix DFE-Gold Series Configuration Manual

set snmp targetparams

Storage type
Row status
Target Parameter Name
Security Name
Message Proc. Model
Security Level
Storage type
Row status
Target Parameter Name
Security Name
Message Proc. Model
Security Level
Storage type
Row status
Table 5‐9 shows a detailed explanation of the command output.
Table 5-9 show snmp targetparams Output Details
Output...
Target Parameter Name
Security Name
Message Proc. Model
Security Level
Storage type
Row status
set snmp targetparams
Use this command to set SNMP target parameters, a named set of security/authorization criteria
used to generate a message to a target.
Syntax
set snmp targetparams paramsname user user security-model {v1 | v2c | usm} message-
processing {v1 | v2c | v3} [noauthentication | authentication | privacy] [volatile
| nonvolatile]
Parameters
paramsname
user user
= nonVolatile
= active
= v2cExampleParams
= public
= SNMPv2c
= noAuthNoPriv
= nonVolatile
= active
= v3ExampleParams
= CharlieDChief
= USM
= authNoPriv
= nonVolatile
= active
What it displays...
Unique identifier for the parameter in the SNMP target parameters
table. Maximum length is 32 bytes.
Security string definition.
SNMP version.
Type of security level (auth: security level is set to use authentication
protocol, noauth: security level is not set to use authentication
protocol, or privacy).
Whether entry is stored in volatile, nonvolatile, or read-only memory.
Status of this entry: active, notInService, or notReady.
Specifies a name identifying parameters used to generate SNMP
messages to a particular target.
Specifies an SNMPv1 or v2 community name or an SNMPv3 user name.
Maximum length is 32 bytes.
Enterasys Matrix DFE-Gold Series Configuration Guide 5-27
Configuring SNMP Target Parameters