Table of Contents
Advertisement
Network Management
Managing General Device Settings
9.2.1.3
show cdp
Use this command to display the enable state of the CDP discovery protocol and message interval
on one or more ports.
show cdp [port_string]
Syntax Description
port_string
Command Defaults
If port_string is not specified, the CDP state for all ports will be displayed.
Command Mode
Read-Only.
Examples
This example shows how to display CDP information for all ports:
Matrix>show cdp
CDP
------- --------- ----
This example shows how to display CDP for Gigabit Ethernet front panel port
Matrix>show cdp ge.0.3-11
-------- --------- ----
9-4
Matrix E1 Series (1G694-13) Configuration Guide
(Optional) Specifies the port(s) for which CDP state will be
displayed. For a detailed description of possible port_string
values, refer to
: auto
Port
State
Freq
ge.0.1
auto
ge.0.4
auto
ge.0.7
auto
ge.0.10 auto
Port
State
ge.0.3
enabled
ge.0.4
auto
ge.0.5
disabled
ge.0.6
auto
ge.0.7
auto
ge.0.8
auto
ge.0.9
auto
ge.0.10
auto
ge.0.11
auto
Section
Port
State
------- --------- ----
60
ge.0.2
auto
60
ge.0.5
disabled
60
ge.0.8
auto
60
ge.0.11 auto
Freq
60
60
60
60
60
60
60
60
300
4.1.2.
Freq
Port
-------- ------- -----
60 ge.0.3
enabled
60 ge.0.6
auto
60 ge.0.9
auto
300 ge.0.12 auto
s 3 through 11.
State
Freq
60
60
60
60
Advertisement
Table of Contents
