Router; Enabling Router Configuration Modes; Router Cli Configuration Modes - Enterasys Matrix DFE-Gold Series Configuration Manual

router

router
Use this command to enter router CLI mode.
Syntax
router
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to enable routing on this router:
Matrix(su)->router
Matrix(rw)->Router>

Enabling Router Configuration Modes

The Matrix CLI provides different modes of router operation for issuing a subset of commands
from each mode. Table
Table 2-9 Router CLI Configuration Modes
Use this mode...
Privileged EXEC
Mode
Global Configuration
Mode
Interface
Configuration Mode
2‐9 describes these modes of operation.
Note: The command prompts used as examples in
operation for a user in Read-Write (rw) access mode, and a system where module 1 and VLAN 1
have been configured for routing. The prompt changes depending on your current configuration
mode, the specific module, and the interface types and numbers configured for routing on your
system.
To...
• Set system
operating
parameters
• Show configuration
parameters
• Save/copy
configurations
Set system-wide
parameters.
Configure router
interfaces.
Table 2-9 and throughout this guide show switch
Access method...
From the switch CLI:
1. Type router, then
2. Type enable.
Type configure
terminal from
Privileged EXEC mode.
Type interface vlan or
interface loopback and
the interface's id from
Global Configuration
mode.
Enterasys Matrix DFE-Gold Series Configuration Guide 2-103
Reviewing and Configuring Routing
Resulting Prompt...
Matrix>Router>
Matrix>Router#
Matrix>router(config)#
Matrix>router
(config-if(Vlan 1 | Lpbk 1))#