Starting And Configuring Telnet; Purpose; Commands - Enterasys SecureStack C2 C2G170-24 Configuration Manual

Example
This example shows how to set the boot firmware image file and reset the system.
C2(su)->set boot system c2_05.02.01.0005
This command requires resetting the entire system.
Do you want to continue (y/n) [n]?y
Checking firmware version
Saving Configuration
This example shows how to set the boot firmware image file to be used at the next reboot of the
system, by answering "n" to the prompt. The dir command is then executed to display the Active
and Boot images.
C2(su)->set boot system c2_05.02.03.0007
This command can optionally reset the system to boot the new image.
Do you want to reset now (y/n) [n]?n
C2(su)->dir
Images:
==================================================================
Filename:
Version:
Size:
Date:
CheckSum:
Compatibility: <platform specific>
Filename:
Version:
Size:
Date:
CheckSum:
Compatibility: <platform specific>

Starting and Configuring Telnet

Purpose

To enable or disable Telnet, and to start a Telnet session to a remote host. The SecureStack C2
switch allows a total of four inbound and / or outbound Telnet session to run simultaneously.

Commands

For information about...
show telnet
set telnet
telnet
c2_05.02.00.0026 (Active)
05.02.00.0026
9405440 (bytes)
Fri Jul 18 12:48:35 2008
f1626ccf10d8f48cd6c3e79ab602342a
c2_05.02.03.0007 (Boot)
05.02.03.0007
8290304 (bytes)
Fri May 9 11:35:27 2008
9f820d79239f10890442f8ff1f2bc914
Starting and Configuring Telnet
Refer to page...
3-36
3-36
3-37
SecureStack C2 Configuration Guide 3-35