Chrysler 2005 Crossfire SRT6 Service Manual page 632

7 - 88 ACCESSORY DRIVE
3. Install the wrench on the tensioner and remove the
tensioner locking pin (1).
4. Install the accessory drive belt. (Refer to 7 -
COOLING/ACCESSORY DRIVE/DRIVE BELTS -
INSTALLATION).
5. Install the engine cover (1). Align the engine cover
retaining clips to the rubber mounts, and push
down firmly to connect engine cover to rubber
mounts.
Note: To ease the installation of the engine cover,
apply a small amount of lubricant to the engine
cover rubber mounts.
6. Start the engine and verify the accessory drive belt
is properly routed and seated.
ZH