Trigger:shold:slope - Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual

:TRIGger:SHOLd:SLOPe

Command Syntax
:TRIGger:SHOLd:SLOPe <slope>
<slope> ::= {NEGative | POSitive}
The :TRIGger:SHOLd:SLOPe command specifies whether the rising edge or
the falling edge of the clock signal is used.
Query Syntax
:TRIGger:SHOLd:SLOPe?
The :TRIGger:SHOLd:SLOPe? query returns the current rising or falling
edge setting.
Return Format
<slope><NL>
<slope> ::= {NEG | POS}
See Also
•
•
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1138)
"Introduction to :TRIGger Commands"
":TRIGger:MODE" on page 886
":TRIGger:SHOLd:SOURce:CLOCk"
":TRIGger:SHOLd:SOURce:DATA"
:TRIGger Commands
on page 877
on page 934
on page 935
31
933