Display The Mld Group Table; Clear Mld Groups; Change The Mld Version; Debug Mld - Dell Force10 C150 Configuration Manual

Ftos configuration guide ftos 8.4.2.7 e-series terascale, c-series, s-series (s50/s25)
Hide thumbs Also See for Force10 C150:
Table of Contents

Advertisement

Display the MLD Group Table

Task
Display MLD groups. Group information
can be filtered, see the FTOS Command Line
Reference for the options available with this
command.

Clear MLD Groups

Clear a specific group or all groups on an interface from the multicast routing table using the command
clear ipv6 mld groups

Change the MLD Version

Task
Change the MLD version.

Debug MLD

Task
Display FTOS messages about the MLD process.

MLD Snooping

Multicast packets are addressed with multicast MAC addresses, which represent a group of devices, rather
than one unique device. Switches forward multicast frames out of all ports in a VLAN by default, even
though there may be only some interested hosts, which is a waste of bandwidth. MLD Snooping enables
switches to use information in MLD packets to generate a forwarding table that associates ports with
multicast groups so that when they receive multicast frames, they can forward them only to interested
receivers.
Command Syntax
show ipv6 mld
from EXEC Privilege mode.
Command Syntax
ipv6 mld version 1
Default: MLD version 2
groups
interface
{
|
}
Command Syntax
debug ipv6 mld
Command Mode
EXEC Privilege
Command Mode
INTERFACE
Command Mode
EXEC Privilege
Multicast Listener Discovery | 611

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents