Isolate Clients Connected To Different Access Points - Digi LR54 User Manual

Wi-Fi
4. Create a new access point or modify an existing access point. See
access point,
point with enterprise
5. Enable Isolate clients.
6. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the LR54
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new access point or modify an existing access point. See
access point,
point with enterprise
4. (Optional) Set the client isolation:
(config)> network wifi ap digi_ap1 isolate_client true
(config)>
5. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Isolate clients connected to different access points

Isolating clients that are on different access points involves the following steps:
1. Assign the access points to separate LAN interfaces.
2. Assign those LAN interfaces to separate firewall zones.
3. Create firewall filters to prevent traffic between the two firewall zones.

Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
LR54 User Guide
Configure a Wi-Fi access point with personal
security.
Configure a Wi-Fi access point with personal
security.
Isolate Wi-Fi clients
Configure an open Wi-Fi
security, or Configure a Wi-Fi access
Configure an open Wi-Fi
security, or Configure a Wi-Fi access
293