Isolate Clients Connected To Different Access Points - Digi IX20-WAG4 User Manual

Wi-Fi
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new access point or modify an existing access point. See
access point,
point with enterprise
4. (Optional) Set the client isolation:
(config)> network wifi ap digi_ap isolate_client true
(config)>
5. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Isolate clients connected to different access points

Isolating clients that are on different access points involves the following steps:
1. Create new access points.
2. Assign the access points to separate LAN interfaces.
3. Assign those LAN interfaces to separate firewall zones.
4. Create firewall filters to prevent traffic between the two firewall zones.

WebUI
1. Log into the IX20 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
IX20 User Guide
Configure a Wi-Fi access point with personal
security.
Isolate Wi-Fi clients
Configure an open Wi-Fi
security, or Configure a Wi-Fi access
214