Installation; Installing And Removing The Master/Slave Card - HBM Genesis GEN5i User Manual

GEN5i
11.7.2

Installation

Installing and removing the Master/Slave card

The Master/Slave card is easily inserted into the GEN series mainframe and is
automatically recognized by the Perception software.
The card is removed and installed in the same way as all the acquisition cards.
Note On the GEN series 19" rack model remove the acquisition card from slot A.
CAUTION
HBM uses state-of-the-art electronic components in its equipment. These
electronic components can be damaged by a discharge of static
electricity (ESD). Therefore, we must emphasize the importance of ESD
preventions when removing or installing cards/modules.
CAUTION
The GEN series Data Acquisition System is factory-calibrated as
delivered to the customer. Swapping, replacing or removing of cards/
modules may result in minor deviations to the original calibration. The
GEN series system should be tested and if necessary, calibrated, at one-
year intervals or after any major event that may affect calibration. When
in doubt, consult your local supplier.
LASER SAFETY
CLASS 1 LASER PRODUCT. Avoid exposure to laser radiation. Do not
stare into an open aperture, because invisible laser radiation may be
emitted from the aperture when a cable is not inserted in the connector
port. The system is classified as a Class 1 laser product. The Master/Slave
®
card uses an LC Optical Tranceiver for communication. It does not emit
hazardous light but it is recommended to avoid direct exposure to the
beam.
218 I2679-4.0 en