Im2 - Communication And Control - HBM Genesis GEN5i User Manual

146
The IM2 has a unique Communication section with 1 Standard Ethernet
Interface, 1 Optical Ethernet Interface with 2 activity LEDs and a Master Slave
Interface with 2 activity LEDs. The 4 I/O connectors are very similar to the IM1
connectors however the reset switch on the IM2 is above the first connector on
this module. The first connector on this module is labeled EXT CLK IN.
The IM2 is built from three main sections; the I/O Connectors, the
Communication section and the Expansion slot.

IM2 - Communication and Control

11.2.1
The GEN5i uses standard TCP/IP protocol over Ethernet to communicate with
your PC. The system controller/Interface Modules provides access to the
Ethernet network.
The module is equipped with:
1 Standard copper Ethernet interface with 100/1000 Base-T Gigabit
l
support (connect to the RJ-45 Interface).
1 Fiber optic interface (Install and connect to the SFP module option).
l
1 M/S Master Slave interface (Connect to the SC Interface).
l
LED's are used to indicate activity as well as connection. The following
describes the LED activity of the front panel of the IM2.
Standard Interface (RJ45) Cat 5e UTP, 1 Gbit/s
L = Link up/active
(green)
On; Link up
Off; Link down
Blinking; Active
1 Gbit Optical SFP Interface
L = Link up/active
(green)
On; Link up
Off; Link down
Blinking; Active
GEN5i
S = Speed (yellow)
On; 100 Mbit
Off; 1000 Mbit
S = Speed (yellow)
On; 100 Mbit
Off; 1000 Mbit
I2679-4.0 en