HBM Genesis GEN5i User Manual page 160

160
After the GEN DAQ is configured the NAS should be configured. To configure
the NAS, use the manufacturers guides. An example of further Synology
configuration is given in the appendix "Setting up the iSCSI with Synology
NAS" on page 574. If you have a Synology
in the Appendix.
Note All IP addresses are best set to Fixed IP to avoid changing IP addresses when
a system performs a power cycle.
2 Setup in Perception:
Start Perception and navigate to the Settings menu via the Settings tab
and select External Storage Setup.
Please make sure you have read section Explaining the External Storage
Setup Dialog (see Figure 11.11) before executing this procedure.
The External Storage Setup dialog:
The information in this dialog must match the information defined in the
configuration of the connected NAS. Refer to the appendix "Setting up the
iSCSI with Synology
using Synology
Figure 11.11: External Storage Setup (Setup an iSCSI NAS connected
across an Ethernet switch)
A GEN Data acquisition system
B iSCSI Host
C iSCSI Target
®
NAS" on page 574 when necessary for an example
®
.
®
system you can follow the steps
GEN5i
®
®
I2679-4.0 en