HBM Genesis GEN5i User Manual page 308

308
Customization and ordering
First check whether there are 5B modules available that do the job with respect
to their fixed input range and the other limitations. Very often the input range is
ok, because the Genesis input cards used behind the 5Bs are offering a
16 bit resolution and therefore most likely high enough resolution for any range
required. Then select the proper module and define the input connectors
needed for the sensor used.
From there the special card can be "customized" on site in local service
department or through an outside vendor.
The 5B Integration card can be ordered from HBM and the 5B modules from
any of the 5B vendors. The cabling, connectors and the specific documentation
have to be done by the designer.
What is included?
When ordering the 5B Integration card, the following components are included:
Figure 12.33: 5B Integration card components
A Genesis 5B Integration card 1x
B Signal conditioner module 6x
C Execution/Genesis blind single with handle 1x
D Bracket/Genesis 5B Carrier Clamp 6x
E PAN/Genesis blind single with handle 1x
F Screw M2.5x0.45 12Torx 2x
G Screw M3x0.5 6ST 2x
H BRKT/Genesis Carrier Airflow 1x
GEN5i
I2679-4.0 en