Installing Modules - HBM Genesis GEN5i User Manual

90
3 Loosen the small set screw on both ejectors on the module.
Figure 7.5: Removing modules (Part 1)
4 Press the inner grey button on each ejector to release the catch.
Figure 7.6: Removing modules (Part 2)
5 Press both ejectors outward to release the module. They act as levers to
gently pull the module from its backplane sockets.
6 Slide the module out of the GEN5i unit.
7.3.2

Installing modules

CAUTION
For correct operation of the instrument, it is imperative that the board with
the lowest maximum sample rate is placed in the slot marked "A".
To install modules proceed as follows:
1 Shut down the GEN5i system and remove the power input cable.
2 Ensure the ejector levers are in the farthest outermost position, tilting away
from the module.
3 Slide the module into its guide rails until the ejectors contact the perforated
metal strips at left and right.
GEN5i
I2679-4.0 en