Making A Multi-Mainframe Recording - HBM Genesis GEN5i User Manual

238
14 In the drop-down list that comes up, select Transceive for all recorders.
Figure 11.77: Master/Slave trigger list
15 Set-up a display with the first channel of the first recorder card in the master
mainframe and the first channel of the first recorder card in the slave
mainframe.

Making a multi-mainframe recording

1 Wait for the "MASTER SLAVE" status to display Synchronized before
proceeding to the next step.
Figure 11.78: MASTER SLAVE Synchronized
2 Press Run in the acquisition control panel to start a recording.
3 The signal on the master mainframe will now generate a trigger event. This
trigger event will be relayed to the slave mainframe.
4 The recording will now show the rising edge of the TTL level 1 Hertz signal
recorded by the master mainframe and the slave mainframe.
5 The recordings in both mainframes are started at the same time.
All recorded signals will match in time to within ± 50 ns.
6
If all signals match in time, the recordings were completed successfully.
GEN5i
I2679-4.0 en