HBM Genesis GEN5i User Manual page 302

302
Figure 12.28: Quadrature measurement pinning layout
Table 12.8: Quadrature measurement bit connector pinning
PIN # EVENT
12 Event Bit 53
11 Event Bit 54
10 Event Bit 55
8 Event Bit 57
7 Event Bit 58
6 Event Bit 59
4 Event Bit 61
3 Event Bit 62
2 Event Bit 63
In the Perception software the event bits are combined within one channel and
labeled as CH1_1 through CH1_64. The counter/timer channels are referred to
as CH2 through CH4.
Clock input (A) The clock input is the actual signal input. The counter will be
incremented on each rising edge of this signal if the direction input is low ("0").
The counter will be decremented on each rising edge of this signal if the
direction input is high ("1").
QUAD. CH. FUNCTION
1 Clock input (A)
1 Direction input (B)
1 Reset
2 Clock input (A)
2 Direction input (B)
2 Reset
3 Clock input (A)
3 Direction input (B)
3 Reset
GEN5i
I2679-4.0 en