11.3.12 Setup An Iscsi Nas Connected Without An Ethernet Switch - HBM Genesis GEN5i User Manual

GEN5i

11.3.12 Setup an iSCSI NAS connected without an Ethernet switch

This is basic setup of a GEN DAQ system with a NAS connected directly at the
GEN DAQ system. A Ethernet switch is not required. All components are locally
based and can be connected to one host PC. This ensures that there is only
one way to communicate with the device which is through the host PC. This is
therefore the most secure way to set up the NAS storage device.
This setup however does not provide the network connection to be able to
configure the NAS storage device.
Figure 11.14: GEN DAQ with directly attached iSCSI NAS
WARNING
The NAS in this setup is NOT configurable. The unit will therefore have to
be connected to PC first to assign an IP address manually, alternatively
create a connection to the company network which you can then remove
later if needed.
I2679-4.0 en 163