HBM Genesis GEN5i User Manual page 328

Options, to be ordered separately
Article
IRIG PMC card
IRIG/GPS PMC
card
Solid State Disk
1 Gbit Optical
Network SFP
module 850 nm
1 Gbit Optical
Network SFP
module 1310 nm
10 Gbit Ethernet
XMC card
10 Gbit Optical
Network SFP+
module 850 nm
10 Gbit Optical
Network SFP+
module 1310 nm
Master/Slave card
328
Description
Factory installed option.
GEN DAQ IRIG interface fits into open XMC/
PMC slot of GEN DAQ Interface/Controller
module.
Cannot be used in combination with 10 Gbit
Ethernet XMC card.
Factory installed option.
GEN DAQ IRIG/GPS interface fits into open
XMC/PMC slot of GEN DAQ Interface/Controller
module, comes with antenna and 15 m cable.
Cannot be used in combination with 10 Gbit
Ethernet XMC card.
Factory installed option.
GEN DAQ Internal SSD drive in GEN DAQ
mainframe, 300 GB capacity, 50 MB/s
continuous streaming rate. Sweep storage rate
depending on sweep length and number of
channels. Short sweeps are stored slower due to
administration overhead.
GEN DAQ 1 Gbit Ethernet SFP, 850 nm Multi
Mode, up to 500 m optical cable length
supported, LC connector support.
1 Gbit SFP modules are not compatible with the
10 Gbit SFP+ modules.
GEN DAQ 1 Gbit Ethernet SFP, 1310 nm Single
Mode, up to 10 km optical cable length
supported, LC connector support.
1 Gbit SFP modules are not compatible with the
10 Gbit SFP+ modules.
Factory installed option.
GEN DAQ 10 Gbit Ethernet XMC card adds up
to 2 extra 10 Gbit Ethernet network connections
to a GEN DAQ series mainframe. Supports up to
200 MB/s continuous data transfer from the GEN
DAQ mainframe to an appropriate PC. Requires
a 10 Gbit optical network SFP+ module. Cannot
be used in combination with IRIG or IRIG/GPS
PMC card.
GEN DAQ 10 Gbit Ethernet SFP+, 850 nm Multi
Mode, up to 66 m optical cable length supported,
LC connector support.
10 Gbit SFP+ modules are not compatible with
the 1 Gbit SFP modules.
GEN DAQ 10 Gbit Ethernet SFP+, 1310 nm
Single Mode, up to 10 km optical cable length
supported, LC connector support.
10 Gbit SFP+ modules are not compatible with
the 1 Gbit SFP modules.
GEN DAQ Master/Slave option. Uses first slot in
GEN16t rack, GEN2i and GEN5i integrated
mainframes and the Master/Slave slot in GEN7t
tower mainframe. The Master/Slave card is
needed in master and any slave mainframe.
Supports up to eight slaves using optical
connections. Single 3 m (10 ft) optical cable
included.
GEN5i
Order No.
1-G001-1
1-G002-2
1-G061-2
1-G062-2
1-G063-2
1-G064-2
1-G065-2
1-G066-2
1-G040-2
I2679-4.0 en