Installation; Installing And Removing The Master/Slave Board - HBM GEN Series User Manual

Daq products (data acquisition system)

Hide thumbs Also See for GEN Series:

Table of Contents

2.2.1

Installation

The Master/Slave board is easily inserted into the GEN series mainframe and is automatically

recognized by the Perception software.

The board is removed and installed in the same way as all the acquisition boards.

Note

On the GEN series 19" rack model remove the acquisition board from slot A.

CAUTION

HBM uses state-of-the-art electronic components in its equipment. These electronic

components can be damaged by a discharge of static electricity (ESD). Therefore, we

must emphasize the importance of ESD preventions when removing or installing boards.

CAUTION

The GEN series Data Acquisition System is factory-calibrated as delivered to the

customer. Swapping, replacing or removing of boards may result in minor deviations to

the original calibration. The GEN series system should be tested and if necessary,

calibrated, at one-year intervals or after any major event that may affect calibration. When

in doubt, consult your local supplier.

LASER SAFETY

CLASS 1 LASER PRODUCT. Avoid exposure to laser radiation. Do not stare into an open

aperture, because invisible laser radiation may be emitted from the aperture when a cable

is not inserted in the connector port. The system is classified as a Class 1 laser product.

The Master/Slave board uses an LC

emit hazardous light but it is recommended to avoid direct exposure to the beam.

The built-in laser complies with laser product standards set by government agencies for Class 1

laser products:

In the USA, the Master/Slave board is certified as a Class 1 laser product conforming to the

requirements contained in the Department of Health and Human Services (DHHS)

regulation CDRH 21 CFR, Chapter I Subchapter J Part 1040.10.

Outside the USA, the Master/Slave board is certified as a Class 1 laser product conforming

to the requirements contained in IEC/EN 60825-1:1994+A1+A2 and IEC/EN 60825-2.

Optical Tranceiver for communication. It does not

I2710-1.0 en

Table of Contents