HBM Genesis GEN5i User Manual page 219

I2679-4.0 en
The built-in laser complies with laser product standards set by government
agencies for Class 1 laser products:
In the USA, the Master/Slave card is certified as a Class 1 laser product
l
conforming to the requirements contained in the Department of Health and
Human Services (DHHS) regulation CDRH 21 CFR,
Chapter I Subchapter J Part 1040.10.
Outside the USA, the Master/Slave card is certified as a Class 1 laser
l
product conforming to the requirements contained in IEC/
EN 60825-1:1994+A1+A2 and IEC/EN 60825-2.
Installing the Master/Slave card
To install the Master/Slave card proceed as follows:
1 Shut down the GEN series and remove the power input cable.
2 Ensure that the ejector levers are in the outermost position, tilting away
from the card.
GEN5i
219