Mechanical Installation; Important Precautions During Installation - HBM PaceLine CLP Mounting Instructions

6

Mechanical installation

6.1

Important precautions during installation

S Handle the transducer with care.
S Should high welding currents flow over the sensor, there is a risk - espe­
cially if the sensor is not fully in contact, that unintentional welding may oc­
cur, and that removal will then no longer be possible. HBM provides highly
flexible EEK ground cables, which can be screwed on above and below the
sensor, to electrically short-circuit it.
S Make sure that the sensor is not loaded with more than the force limit.
The pre-stress force and the force being measured should not usually be
greater than the nominal (rated) force.
WARNING
There is a danger of the transducer breaking if it is overloaded. This can cause
danger for the operating personnel of the system in which the transducer is in­
stalled.
Implement appropriate safety measures to avoid overloads or to protect against
the resulting dangers.
CLP
A03616_04_YI0_02 HBM: public
Mechanical installation
13