Table of Contents
Advertisement
T10FM
4
Mechanical installation
WARNING
Handle the torque flange carefully! The transducer could suffer
permanent damage from mechanical shock (dropping), chemical effects
(e.g. acids, solvents) or thermal effects (hot air, steam).
With alternating loads, you should cement the rotor connection screws
into the mating thread with a screw locking device (medium strength) to
exclude prestressing loss due to screw slackening.
An appropriate shaft flange enables the T10FM torque flanges to be mounted
directly. It is also possible to directly mount a joint shaft or relevant
compensating element (see Fig.3.1) on flange B of the rotor (using an
intermediate flange when required). Under no circumstances must the
permissible limits specified for bending moments, lateral and longitudinal
forces be exceeded. Due to the T10FM torque flanges' high torsional
stiffness, dynamic changes on the shaft train are minimized.
IMPORTANT
The effect on critical bending speeds and natural torsional vibrations
must be checked to avoid overloading the measurement flanges due to
the resonance stepup.
NOTE
For correct operation, comply with the mounting dimensions (see Page
44).
A0894-5.2 en
11
HBM
Advertisement
Table of Contents
