HBM Genesis GEN5i User Manual page 342

Dual
Dual Continuous Specifications
Continuous FIFO memory
Maximum recording time
Maximum aggregate streaming rate per
mainframe
Exceeding aggregate storage rate
Fiber optic link
Light source
Connector
Cable
Analog output GN401 (receiver)
Channels
Connector
Conversion
Outputs
Calibrated full scale Output level
Power requirement GN110 and GN111 (transmitter)
Battery
Power consumption
Operation Time
Battery Recharge
342
Used by enabled channels to optimize continuous streaming rate
Until storage media filled, all recorded data will be stored including sweeps, or user selected
time
Determined by mainframe, Ethernet speed, PC storage medium and other PC parameters;
see mainframe datasheet for details
When exceeding average aggregate streaming rate, sweep storage speed is automatically
reduced to increase aggregate streaming rate, until sweep storage completely stops.
When using a streaming rate selected higher than the aggregate streaming rate of the
system, the continuous memory will act as a FIFO. As soon as this FIFO fills up, the
recording suspends (temporarily no data is recorded). During this period, the internal FIFO
memory is transferred to storage medium. When internal memory (Continuous and Sweep
memory) is completely empty again, the recording automatically resumes. User notifications
added to recording file for post recording identification of storage overrun.
Class 1 laser product
Transfer rate 2 Gbit/s
Wavelength 850 nm
LC duplex on GN401
SCRJ/IP67 duplex on GN110, GN111, GN112 and GN113
Isolation 15
10 Ω/m
Maximum length 800 m (26245 ft); using ISO/IEC 11801 type OM2, OM3 or OM4 cable and no extra couplers.
Each extra LC-LC or SCRJ-SCRJ coupler reduces cable length by typical 100 m (328 ft)
Type Duplex Multi Mode, 50/125 μm, ISO/IEC 11801 type OM2
4; 1 per transmitter channel (GN110, GN111, GN112 and GN113)
4; Metal BNC, one BNC per channel on receiver front panel
100 MS/s D-to-A converter per channel
DAC Resolution 14 bit (0.006 %)
Output filter
Lowpass 10 MHz @ – 3 dB; 6
Output impedance 13 Ω typical
± 5 V; 1 MΩ load
11.1 V @ 6600 mAh, removable, rechargeable, Li-ion
2 batteries installed
6 VA typical, 8 VA maximum
24 hours; 2 batteries installed (12 hours; 1 battery installed)
12.6 V DC, 2.5 to 4 Amps @ 25 °C (77 °F)
th
order Bessel reconstruction filter
GEN5i
I2679-4.0 en