Table of Contents
Advertisement
182
Note
1310 nm Single Mode (SM) and 850 nm Multimode (MM) optical fiber
transceivers use specific cables and connectors therefore please check the
correct mode/specification of fiber optic cable is used.
Cable selection and lengths:
Cables require different properties when they exceed certain lengths based on
the properties of light in an optical fiber.
Single mode
Multi mode
For specifications and ordering information see "B3723-1.0 en (GEN series
GEN5i Portable Data Recorder)" on page 312.
For Installation and removal of the SFP module Please see section "Installation
of 1 Gbit SFP/10 Gbit SFP+ Module" on page 189.
Option - 10 Gbit Ethernet interface
11.5.3
The 10 Gbit Ethernet option is a Factory installed, ready to use Ethernet option
with two available Ethernet interfaces.
The 10 Gbit Ethernet Card can be installed in addition to the standard on-board
1 Gbit Ethernet connection. The 10 Gbit Ethernet Card allows you to double the
throughput speed of communication when compared to the standard 1 Gbit
Ethernet. If installed, the 10 Gbit Ethernet option can replace the use of the
standard 1 Gbit Ethernet connection.
WARNING
Laser Safety
The system is classified as a Class 1 laser product. The SFP uses optical
light source for data and command communication. It does not emit
hazardous light but it is recommended to avoid direct exposure to the
beam.
Cable is a type of cable that has a relatively small light carrying
core and therefore makes fewer internal reflections so that the
path of light is closer to a straight line and thus can travel further
distances.
Cable is a type of cable that has a relatively thicker light
carrying core. Light in a thicker core makes more reflections
and is therefore only suited to shorter distances. The following
table shows what mode of fiber is required for each distance
covered.
GEN5i
I2679-4.0 en
Advertisement
Table of Contents
Troubleshooting
