11.3.11 Setup An Iscsi Nas Connected Across An Ethernet Switch - HBM Genesis GEN5i User Manual

I2679-4.0 en

11.3.11 Setup an iSCSI NAS connected across an Ethernet switch

This is the simplest setup of a GEN DAQ system with the NAS connected
through an Ethernet switch on the same network as the control PC and GEN
DAQ system.
This setup can be used in situations where the individual components of the
system are all connected to the same network via an Ethernet switch, this allows
freedom of placement of each component in the system. This setup enables
network access to configure the NAS and GEN DAQ and to read the data on
the iSCSI storage device.
Figure 11.10: GEN DAQ with iSCSI NAS connected across an Ethernet switch
1 Connect the equipment
Connect the PC via a standard RJ45 Ethernet connection to the Ethernet
l
switch.
Connect the GEN DAQ via a standard RJ45 Ethernet connection to the
l
Ethernet switch.
Connect the NAS via a standard RJ45 Ethernet connection to the Ethernet
l
switch.
Please read "PC connections" on page 83 for GEN DAQ setup.
At this stage you should make sure all connections and configurations are
correct.
GEN5i
159