Table of Contents
Advertisement
I2679-4.0 en
11.7.7
Setting the synchronization source (Sync source)
Depending on the selected synchronization source the date and time are
controlled by either the PC (RTC), or an installed IRIG (IRIG) or IRIG/GPS
(GPS) card. The source is selected in the Perception software.
In the Perception work area:
Figure 11.73: Perception work area synchronization source
A
Settings tab
B
General group
C
Sync source column
To set the synchronization source in the Perception software, proceed as
follows:
1
If it is not already active, start Perception.
2
Make sure that you are connected to the required mainframes. Use the
Hardware Navigator to do this.
3
Select the Settings sheet.
4
In the Settings sheet, go to the General group in the task pane and select
Mainframe.
A list of available mainframes is displayed in the settings area.
5
Select the mainframe that you want to set.
Note
In a Master/Slave configuration, the synchronization source cannot be set if the
Master/Slave card of the selected mainframe is operating in Slave mode!
6
Double-click on the Sync source cell to open it for modification.
7
In the drop-down list that comes up, select the synchronization source you
want to use.
GEN5i
235
Advertisement
Table of Contents
Troubleshooting
