HBM Genesis GEN5i User Manual page 17

I2679-4.0 en
It is also essential to follow the respective legal and safety regulations for the
application concerned during use. The same applies to the use of accessories.
Additional safety precautions must be taken in setups where malfunctions could
cause major damage, loss of data or even personal injury.
Some examples of precautions are: mechanical interlocking, error signaling,
limit value switches, etc.
Maintenance and cleaning
The instrument is a maintenance-free product. However in case one wants to
clean the housing please note the following:
Before cleaning, disconnect the instrument completely.
l
Clean the housing with a soft, slightly damp (not wet!) cloth. Never use
l
solvents, since these could damage the display or the labeling on the front
panel.
When cleaning, ensure that no liquid gets into the housing or connections.
l
General dangers, failing to follow the safety instructions
This instrument is a state of the art device and as such is fail-safe. This
instrument may give rise to dangers if it is inappropriately installed and operated
by untrained personnel. Any person instructed to carry out installation,
commissioning, maintenance or repair of the unit must have read and
understood the User Manual and in particular the technical safety instructions.
Remaining dangers
The scope of supply and performance of this instrument covers only a small
area of measurement technology. In addition, equipment planners, installers
and operators should plan, implement and respond to the safety engineering
considerations of measurement technology in such a way as to minimize
remaining dangers. Prevailing regulations must be complied with at all times.
There must be reference to the remaining dangers connected with
measurement technology.
Conversions and modifications
This instrument must not be modified from the design or safety engineering
point of view except with our prior express written agreement. Any modification
shall exclude all liability on our part for any resultant damage. In particular, any
repair or soldering work on motherboards (replacement of components) is
prohibited. When exchanging complete units, use only original parts from HBM.
The unit is delivered from the factory with a fixed hardware and/or software
configuration. Changes should only be made within the possibilities
documented in this manual.
GEN5i
17