HBM Genesis GEN5i User Manual page 494

Digital Input Section
Component
RPM mode
Frequency mode
On-board Memory
Component
Per card
Per channel
Usable memory is:
Acquisition Modes
Component
Sweeps
Continuous
Dual
Slow fast sweep
Storage Modes
Component
Recorder
Scope
Transient
494
Unit Description
Reset to "0" Manual by user
l
At start of recording
l
By reset pin once after start of recording
l
By reset pin always
l
Count size
Maximum frequency
Direction External
Gate time User selectable in 1, 2, 5 steps
Inaccuracy Gate time
Measurement Counts and period
Pulse per rotation User selectable
RPM Counts/(period * pulse per rotation)
Count size
Maximum frequency
Direction External
Gate time User selectable in 1, 2, 5 steps
Inaccuracy Gate time
Measurement Counts and period
Frequency Counts/period
Unit Description
The memory splits between marker inputs and counter/timers
channels.
Markers enabled only (1-64)
Markers plus 1 counter Ch enabled
Markers plus 2 counter Ch enabled
Markers plus 3 counter Ch enabled
Description
Triggered acquisition to RAM without sample rate limitations; for single or repetitive transients or
intermittent phenomena.
Direct storage to PC or mainframe hard disc without file size limitations; triggered or un-triggered; for long
duration recorder type applications with up to 1 MS/s rate per channel; (maximum aggregate rate pending
from mainframe configuration and PC).
Combination of Sweeps and Continuous; recorder type streaming to hard disc with simultaneously
triggered sweeps in RAM.
A triggered acquisition in RAM which includes an acquisition phase with a higher sample rate, located at
a point of interest.
Description
Spooled directly to hard-disk of control PC; unlimited file size or duration
Store in transient memory
Store in transient memory, single or A-B-A time base
GEN5i
Value
64 bits
10 MHz
Up/down
1 ms to 10 sec
10 ns
64 bits
10 MHz
Up/down
1 ms to 10 sec
10 ns
Value
512 MB
64 MS
32 MS
20 MS
16 MS
I2679-4.0 en