Table of Contents
Advertisement
184
Front panel layout
The front panel of the 10 Gbit Ethernet option has the following layout:
Figure 11.33: Front panel of XMC401 10 Gbit Ethernet Card
A
CH B = NIC2 (Requires SFP+ module, not shown)
B
ACT (green): Ethernet Activity (on when active)
C
LNK (green): Ethernet Link (on when active)
D
10 Gbit (green): Ethernet Speed 10 Gigabit (always on)
E
1 Gbit (green): Ethernet Speed 1 Gigabit (always on)
F
CH A = NIC1 (Requires SFP+ module, not shown)
Figure 11.33 shows the two interfaces of this option without installed SFP+
option, for further details on the SFP+ options please see the next section .
Once the SFP+ option is installed in the 10 Gbit Ethernet interface, an LC optical
cable can be connected.
10 Gbit Ethernet Option accessories
The 10 Gbit Ethernet card supports two (10 Gbit) SFP+ modules which are
separately available, see options in the specifications sheet of this section for
ordering.
GEN5i
I2679-4.0 en
Advertisement
Table of Contents
Troubleshooting
