HBM Genesis GEN5i User Manual page 173

I2679-4.0 en
1 Connect equipment
Connect the PC via standard RJ45 Ethernet connection to the Ethernet
l
switch.
Connect the GEN DAQ system by using both the standard RJ45
l
Ethernet and the 1 Gbit optical Ethernet interface to the Ethernet
switch.
Connect the NAS by using a standard RJ45 cable to the Ethernet
l
switch.
Connect the Ethernet switch to your company network using a
l
standard RH45 cable.
At this stage you should make sure all connections and configurations are
correct. The GEN DAQ should resolve an auto IP address in a few
moments after being turned on. Then we should configure the NAS with
Perception. To configure the NAS, please connect a network cable or
connect the NAS to a network temporarily and then follow the
manufacturers guides, this will enable you to determine an IP address for
the NAS server.
2 Setup in Perception:
Start Perception and navigate to the Settings menu and select External
Storage Setup.
GEN5i
(See Figure 11.23)
(See Figure 11.24)
173