Table of Contents
Advertisement
I2679-4.0 en
®
Windows
Interrupt moderation rate: high
l
Receive side scaling ques: 8
l
Receive buffers: 2048
l
For more information on how to do this please see appendix "Optimal Windows
settings for 10Gbit Ethernet Card" on page 566.
Note
The above Windows settings were tested and chosen using a specific setup of
equipment (Intel
optimal settings for your specific system.
11.5.4
Installation of 1 Gbit SFP/10 Gbit SFP+ Module
Introduction
This section covers the installation and removal of the Small Form Factor
Pluggable (SFP or SFP+) transceiver device from any interface supporting SFP
or SFP+ modules.
This device enables an Optical Network connection to be plugged directly into
the front panel, Optical Network interface of the IM2. It is also a necessary
option for the 10 Gbit Ethernet card.
Warnings
Before installing this device please make sure you read the following warning
which are specific for this device.
Description of Electro Static Discharge (ESD)
CAUTION
Electrostatic discharge (ESD) can cause damage to electronic devices if
discharged into the device, so you should take steps to avoid such an
occurrence
7 10G network adapter settings:
®
Ethernet Server adaptor x520). These setting may not be the
GEN5i
189
Advertisement
Table of Contents
Troubleshooting
