HBM Genesis GEN5i User Manual page 175

I2679-4.0 en
GEN DAQ - Network interface:
3
If you have connected the NAS server to the RJ45 connector of the GEN
series mainframe then select the Standard 1Gbit Ethernet.
Figure 11.25: Network interface connections/Standard 1 Gbit option
Or
If you have connected the NAS server to the Optical network connector of
the GEN series mainframe then select the Optical 1Gbit Ethernet.
Figure 11.26: Network interface connections/Optical 1 Gbit option
4 iSCSI Host
DNS Name/IP Address
l
As the setup is part of a corporate network, a DNS setting should be
used in this setup. Therefore select the DNS name option and use the
same DNS name as was used in the setup of the NAS.
When using a Synology
®
Synology Assistant software. This software displays all the known
connected Synology
(For more information, please refer to Figure J.7 "Create a new iSCSI
target dialog" on page 580).
Port number:
l
Default: 3260 When using a Synology
set on the default of 3260. Can sometimes be found in the NAS
configuration of the manufacturers software.
5 iSCSI Target
Target name (IQN):
l
This is the IQN name, it can be found by looking at the manufacturers
software supplied with the NAS. An example for Synology
setup is in appendix "Setting up the iSCSI Synology
page 574.
®
NAS, the IP address is displayed in the in the
®
devices.
® NAS the port number must be
GEN5i
(See Figure 11.24 - A)
(See Figure 11.24 - B)
(See Figure 11.24 - C)
®
iSCSI
®
NAS" on
175