External Storage Setup Dialog - Perception; Gen Data Acquisition System - HBM Genesis GEN5i User Manual

I2679-4.0 en

External Storage Setup dialog - Perception

11.3.3
To setup a NAS device in software Perception, first connect to the GEN DAQ
system used for iSCSI storage, open Perception and navigate to the
Settings menu and click External Storage Setup.
Figure 11.6: External Storage Setup dialog
A

GEN Data acquisition system

B iSCSI Host
C iSCSI Target
This setup dialog shows the connected mainframes and their available external
storage sources. If supported these storage sources will show up here. Click
on the iSCSI label to select one.
11.3.4
GEN Data acquisition system
This selection box shows the available network interfaces that are installed on
the GEN DAQ system. Click the drop-down box and then select the correct
network interface that your NAS is connected to, this setting must be correct
for any of the further settings to take effect.
It is possible to connect a NAS server on iSCSI 1 and iSCSI 2 at the same time
but not possible to use them both at the same time.
GEN5i
(See Figure 11.6 - A)
153