HBM Genesis GEN5i User Manual page 168

168
Figure 11.19: GEN DAQ with iSCSI NAS connected across an Ethernet switch
and connected to a corporate network
1 Connect Equipment:
The Ethernet switch should be connected to the Company network.
Connect the PC via a standard RJ45 Ethernet connection to the
l
Ethernet switch. If an optical Ethernet interface is available, use this.
Connect the GEN DAQ system via a standard RJ45 Ethernet
l
connection to the Ethernet switch. If an Optical Ethernet interface is
available, use this.
Connect the NAS via a standard RJ45 Ethernet connection to the
l
Ethernet switch. Some NAS servers also support optical connections
in which case they can be used.
Please read "PC connections" on page 83 for GEN DAQ setup.
At this stage you should make sure all connections and configurations are
correct. The GEN DAQ should resolve an auto IP address in a few
moments after being turned on. Then we should configure the NAS with
Perception. To configure the NAS, please connect a network cable or
connect the NAS to a network temporarily and then follow the
manufacturers guides, this will enable you to determine an IP address for
the NAS server.
GEN5i
I2679-4.0 en