HBM Genesis GEN5i User Manual page 161

I2679-4.0 en
GEN Data acquisition system - Network
3
interface:
Select the Standard 1 Gbit Ethernet port that is connected to the Ethernet
switch.
Figure 11.12: Network interface connections/Standard 1 Gbit option
4 iSCSI Host
DNS Name/IP Address:
l
A DNS setting is not used in this setup. When DNS is not available the
IP address must be filled in, therefore select the IP address option and
use the same IP address that was used in the setup of the NAS. Make
sure the IP address of the NAS is a fixed IP address so it does not
change after reboot.
When using a Synology
the Synology
connected Synology
Synology
Port number:
l
Default: 3260
Can sometimes be found in the NAS configuration of the
manufacturers software.
Note
When using a Synology
3260.
5 iSCSI Target
Target name (IQN):
l
This is the IQN name, it can be found by looking at the manufacturers
software supplied with the NAS. An example for Synology
setup is in appendix "Setting up the iSCSI Synology
page 574.
Use CHAP:
l
Select Use CHAP if CHAP password protection was selected during
the setup of your NAS server. When using a Synology
password protection can be selected.
(For more information, please refer to Figure J.7 "Create a new iSCSI
target dialog" on page 580).
®
NAS, the IP address is displayed in the in
®
Assistant software. This software displays all the known
®
devices. See details: "Setting up the iSCSI
®
NAS" on page 574.
®
NAS the port number must be set on the default of
GEN5i
(See Figure 11.11 - A)
(See Figure 11.11 - B)
(See Figure 11.11 - C)
®
iSCSI
®
NAS" on
®
NAS, CHAP
161