HBM Genesis GEN5i User Manual page 166

166
Or
If you have connected the NAS server to the Optical network connector of
the GEN series mainframe then select the Optical 1 Gbit Ethernet.
Figure 11.17: Network interface connections/Optical 1 Gbit option
4 iSCSI Host
DNS name/IP address
l
A DNS setting is not used in this setup. When DNS is not available the
IP address must be filled in. Therefore select the IP address option and
use the same IP address that was used in the setup of the NAS.
When using a Synology
®
the Synology
connected Synology
(For more information, please refer to Figure J.1 "Synology Assistant"
on page 574).
Port number:
l
Default: 3260
Can sometimes be found in the NAS configuration of the
manufacturers software.
When using a Synology
default of 3260.
5 iSCSI Target
Target name (IQN):
l
This is the IQN name, it can be found by looking at the manufacturers
software supplied with the NAS. An example for Synology
setup is in appendix "Setting up the iSCSI with Synology
page 574.
Select Use CHAP if CHAP password protection was selected during
l
the setup of your NAS server.When using a Synology
password protection can be selected.
(For more information, please refer to Figure J.7 "Create a new iSCSI
target dialog" on page 580).
User name:
l
Enter the details used during the setup procedure of the CHAP
authentication on the NAS. If none were chosen, leave these field
blank.
®
NAS, the IP address is displayed in the in
Assistant software. This software displays all the known
®
devices.
®
NAS the port number must be set on the
GEN5i
(See Figure 11.11 - B)
(See Figure 11.11 - C)
®
iSCSI
®
NAS" on
® NAS, CHAP
I2679-4.0 en