12 Input Cards; Available Input Cards - HBM Genesis GEN5i User Manual

12 Input Cards

I2679-4.0 en
12.1

Available input cards

●
Isolated 1kV
For use with especially high voltage inputs, externally conditioned signals
or isolated voltage probes and current clamps. The isolated balanced
differential inputs allow direct connection to any voltage up to 600 VRMS
on either input of each channel. The signal conditioner provides six
channels of voltage inputs from ± 20 mV to ± 1000 V.
- on page 258
●
Basic
Ideally suited for high definition transient recording. 8 channels with
single-ended or isolated inputs on one board.
200 kS/s or 1 MS/s digitizing rate. 16-bit resolution. The signal conditioner
provides eight channels of voltage inputs from ± 1 V to ± 50 V.
●
Basic XT
Has all the features of the basic input card with higher voltage input ranges
up to ± 100 V. 8 channels with single-ended or isolated inputs on one board.
200 kS/s or 1 MS/s digitizing rate. 16-bit resolution. The signal conditioner
provides eight channels of voltage inputs from ± 2 V to ± 100 V.
- on page 264
●
Bridge
Bridge wizard for error-free setup and fast auto balance. 200 kS/s and
1 MS/s versions. Isolated and differential inputs. High gain, extremely good
SNR even at the maximum 400 kHz bandwidth. Both versions come with
on-board, software selectable shunt calibration and bridge completion
resistors.
●
Universal
Unique high-end card serves a variety of needs. Differential and/or isolated
measurements to IEPE-based vibration or shunt-based current
measurements.
Supports any type of 'constant current' vibration and acceleration sensors.
In "current mode" the built-in shunt can be used to measure up to 1 ampere
in a safe, isolated and fused manner, without the need of external shunt
resistors.
●
Binary Marker
A special input board enables up to 64 "digital" recorded channels.
This board can be used to record status signals from the process or test;
like high/low, open/closed or left/right. In addition 3 counter/timer channels
are available.
●
Binary Marker HV
A general purpose card that is also specifically suited for the medium/high
voltage market.
Acquire 32 digital event signals (markers) as well as 8 digital event signals
that are optically isolated. More details can be found in the BE3200 manual.
- on page 244
- on page 261
- on page 289
- on page 296
- on page 297
GEN5i
239