HBM Genesis GEN5i User Manual page 240

240
●
High Resolution IEPE and Charge
Developed for versatility in the following application areas:
As a differential amplifier or non-isolated entry level electrical input
amplifiers. In Accelerometer mode they offer inputs for an array of IEPE
based sensors. In Charge mode they can be used directly with charge type
sensors. In Single ended mode the cards can serve as coupler inputs for
preconditioned signals.
●
High speed digitizers
For ultra fast signals 25 MS/s and 100 MS/s versions. Equipped with four
channels sampling at incredibly high speed. Selectable anti-aliasing
filtering and 14-bit (100 MS/s) or 15-bit resolution (25 MS/s). Enhanced
resolution mode increases input resolution for both models to 16-bit. Inputs
are single ended or differential. The 25 MS/s digitizer replaces the
20 MS/s high speed digitizer that was produced before 2007.
●
5B Integration card
In situations where non-standard or specific card requirements are needed,
for example LVDT or PT100 signals that need to be conditioned and
acquired, the 5B Integration card is used.
●
High voltage modules
The Isolated GN401, GN110, GN111, GN112 and GN113 are a complete
programmable single-channel digitizing subsystem for use in the GEN
DAQ system. The transmitters are designed to provide for high voltage
isolation while maintaining high dynamic accuracy. It is typically used for
accurate isolated measurements in harsh environments.
The Isolated transmitters come in two models to best fit your requirements.
A high voltage / high power model that you can use in even the most
demanding applications and harsh environments, and a medium voltage /
medium power model. This last front-end can be connected directly to the
mains. The built-in power supply provides isolation up to 1.8 kV.
Up to 4 Isolated Digitizers (channels) can be connected to a single receiver
module.
These digitizers and modules are described in a separate document.
- on page 290
- on page 291
- on page 305
- on page 331
GEN5i
I2679-4.0 en