Setting The Master/Slave Trigger - HBM Genesis GEN5i User Manual

232
11.7.6

Setting the Master/Slave trigger

When the Master/Slave card is in use, a recorder can either put the recorder
trigger on the Master/Slave trigger line and/or pick up the trigger from the
Master/Slave trigger line.
There are four settings that can be selected in the Perception software:
Disabled
l
No trigger transmitted to or received from other mainframes
Transmit
l
Transmit trigger(s) from this recorder to other mainframes
Receive
l
Receive trigger(s) from other mainframes
Transceive
l
Transmit and receive trigger(s) from other mainframes
The settings are controlled in a block diagram or through the Master/Slave
trigger setting in the sheet.
Figure 11.70: Block diagram
GEN5i
I2679-4.0 en