HBM Genesis GEN5i User Manual page 164

164
1 Connect Equipment
Connect the PC via an Optical Ethernet connection to the optical Ethernet
connector of the GEN DAQ system. Connect the NAS to the GEN DAQ
system via the Standard RJ45 connection or if the option is installed use
a second optical Ethernet connection.
OR
Connect the PC via a standard RJ45 Ethernet connection to the GEN DAQ
system's standard RJ45 connector. Connect the GEN DAQ system via the
Optical Ethernet connection to the NAS servers Optical Ethernet
connector.
Please read "Connecting the GEN series directly to your PC" for GEN DAQ
setup in the GEN DAQ manual.
At this stage you should make sure all connections and configurations are
correct. The GEN DAQ should resolve an auto IP address in a few
moments after being turned on. Then we should configure the NAS with
Perception. To configure the NAS, please connect a network cable or
connect the NAS to a network temporarily and then follow the
manufacturers guides, this will enable you to determine an IP address for
the NAS server.
Note All IP addresses are best set to Fixed IP.
2 Setup in Perception:
Start Perception and navigate to the Settings menu and select External
Storage Setup.
Please make sure you have read section Explaining the External Storage
Setup Dialog (see Figure 11.11) before executing this procedure.
GEN5i
(See Figure 11.14)
(See Figure 11.15)
I2679-4.0 en