HBM Genesis GEN5i User Manual page 91

I2679-4.0 en
4 Press both ejectors inward to seat the module. They act as levers to gently
pull the module into its backplane sockets. The gray button should snap to
its default position and lock the ejectors.
5 Tighten the small set screw on both ejectors on the of the card/module:
Figure 7.7: Card/module ejectors with screws
WARNING
Screws must be locked to meet CE emissions.
WARNING
Any empty slots must be covered with a blank panel with thermal strip on
the back to meet the cooling requirements of the mainframe.
GEN5i
91