HBM Genesis GEN5i User Manual page 557

I2679-4.0 en
In the Setup of Display dialog select the Annotation & Grid tab.
For external time base recordings select the X-Annotation scaling to Position.
Within this mode there are three ways to show the X-axis.
Figure G.5: Display Setup dialog - Annotation & Grid
A
X-Annotation/Position check box
B Linear
C Rotational, 360 degrees per cycle
D Rotational, 720 degrees per cycle
A Linear
The X position is expressed in units as selected at the Mainframe –
"Memory & Time base" settings dialog.
Eg. 1000 degrees will show as 1000 degrees on the X-axis.
B Rotational, 360 degrees per cycle
The X position is expressed by 360 degrees cycles and the number of
remaining degrees.
Eg. 1200 degrees will show as 3:120 3 Cycles and 120 degrees.
GEN5i
557