HBM Genesis GEN5i User Manual page 317

Recorder Communication and Control
Network Interface
Optional 1 Gbit/s Ethernet, optical
Optional 10 Gbit/s Ethernet, optical
TCP/IP
Maximum Transfer Speed
1 Gbit/s network to a remote PC
10 Gbit/s network to a remote PC
CPU and Software
(1) Tested using several combinations of acquisition modules.
(2) Linux GPL open source code can be downloaded from HBM website.
(3)
Tested using Windows
Time base and Master/Slave Synchronization
(1)
Central Time base
Master/Slave Synchronization
(1) The Interface/Controller module provides a central time base for all acquisition cards.
Systems shipped before January 2012: ± 30 ppm.
(2)
I2679-4.0 en
Instrument Control 1 Gbit/s, Ethernet
(use fixed TCP/IP address: 172.16.5.1, access covered by protective housing)
1 Gbit/s, optical SFP module using LC connector
850 nm optical wavelength, MultiMode fiber cable, 500 m maximum length or
1310 nm optical wavelength, SingleMode fiber cable, 10 km maximum length.
Uses dedicated SFP interface
Maximum 2 interfaces of 10 Gbit/s optical SFP+ modules using LC connectors
850 nm optical wavelength, MultiMode fiber cable, 66 m maximum length or
1310 nm optical wavelength, SingleMode fiber cable, 10 km maximum length
Uses the XMC/PMC expansion slot
Protocol IPv4
Address setup DHCP/Auto IP or fixed IP
DHCP setup
When DHCP fails Auto IP setup is used similar to Windows
Gateway setup Gateway setup supported for control through VPN and/or Internet
Instrument Control
50 MB/s; 100 MB/s using solid state disk options
100 MB/s
200 MB/s
CPU ATOM based
Operating System (2)
Linux
®
7 PC using Intel i7 CPU and SSD RAID drive with write speeds exceeding 700 MB/s sustained.
Accuracy ± 3.5 ppm; aging after 10 years ± 10 ppm
Clock base Binary, Decimal or External
Supported by the optional Master/Slave card
Master/Slave Synchronization connector only supported by GEN2i mainframes
(1)(3)
(1)(3)
®
PCs
(1)
(2)
GEN5i
317