Tcp/Ip Connection With An Nas - HBM Genesis GEN5i User Manual

GEN5i
11.3.2

TCP/IP connection with an NAS

To enable the GEN DAQ system to communicate with the storage device,
several layers of communication need to be established.
There are several ways to make these connections with different setups. When
using a dedicated network as shown in Figure 11.5 with no other systems
attached, a fixed IP address must be setup on your NAS. As a result it is highly
recommended to also have the PC and GEN DAQ system set to fixed IP
address setup. Other ways to setup this configuration are described in
examples later in this chapter.
Note Setting up the network interface on the NAS server can be found in the
®
manufacturers NAS server handbook. An example of the Synology NAS
®
server setup is given in appendix "Setting up the iSCSI with the Synology NAS"
on page 574.
Make sure that the GEN DAQ system and the NAS server are within the same
network range using shared netmask and IP ranges so they can communicate
with each other.
152 I2679-4.0 en