Operation Of Electrical Installations - HBM Genesis GEN5i User Manual

GEN5i
2.10

Operation of electrical installations

Working on, with, or near electrical installations imply certain dangers. These
electrical installations are designed for the generation, transmission,
conversion, distribution and use of electrical power. Some of these electrical
installations are permanent and fixed, such as a distribution installation in a
factory or office complex, others are temporary, such as on construction sites
and others are mobile or capable of being moved either whilst energized or
whilst not energized nor charged.
The European Standard EN 50110-1 sets out the requirements for the safe
operation of and work activity on, with, or near these electrical installations. The
requirements apply to all operational, working and maintenance procedures.
The European Standard EN 50110-2 is a set of normative annexes (one per
country) which specify either the present safety requirements or give the
national supplements to these minimum requirements at the time when this
European Standard was prepared.
WARNING
High Voltage and qualified personnel
For measurements falling within the scope of the EN 50110-1 and
EN 50110-2, please note that all boards with working voltages above
50 V AC RMS or 120 V DC may only be connected by a qualified technician or
a person trained in electrical engineering and supervised by a qualified
technician. (Qualified technicians are persons who, due to their specialist
training, knowledge and experience as well as their knowledge of the relevant
provisions are able to assess the work with which they are entrusted and detect
possible risks and who have been nominated as qualified technicians by their
employer).
46 I2679-4.0 en